wesnrach
Posts: 58
Status: offline
|
Well, at first I tried to do a true dual snorkel but I messed up bad with the airbox and decided to just run a 1.5'' vacuum hose from the original intake place on the airbox.
I first started from the airbox and ran a short piece of 2'' pvc pipe throungh the airbox, then from the 2'' pvc I adapted the 2''pvc to the 1.5'' vacuum hose and ran it through the rubber strap next to the gas tank and through the splashguard or inner fender.From this point I adapted it to a 90degree 2'' pvc pipe then adapted this to a 2'' to3'' pvc adapter to what you see is ran from the top of my fender, more or less for looks and that beefy look that I like so much.But my new airbox will be here tomorrow, I had to order a new one since I drilled a big hole in the side of my original one but I will test it out here in about 2 1/2 to 3 weeks and let ya'll know how it does and hold up. By the way when you are working to get a water tight seal or close to it, use pvc cement for the pvc fittings and use plumbers goop for anything you think will need it.
Here's some pics....
Here is how I have it to sit straight up for right now and it works well with holding it sturdy, just a few hose clamps around the pvc to the racks.
Here is the best pic of it,
|
Inbox 
Printable Version
need 680 snork pics - 
New Messages
No New Messages
Hot Topic w/ New Messages
Hot Topic w/o New Messages
Locked w/ New Messages
Locked w/o New Messages
Post New Thread
