got four wheel drive?

got four wheel drive? (Full Version)

All Forums >> [OEM Discussions] >> Arctic Cat



Message

exklueziv -> got four wheel drive? (7/24/2008 1:57:44 PM)

cuz I DONT!![:@]

I need an acuator.  anyone have a good one laying around?
Tony's got one, but he may want to keep it as a spare.
BTW tony where you get it?

I took my cover off--  so clean; no mud- but the plastic parts are cracked

also,  can I punch that pin through and run it in 4x4 until my new one comes in?  If so what is the trick to that without damaging anything?



futuremudster -> RE: got four wheel drive? (7/24/2008 2:01:00 PM)

Texasdawg had one but he's never on anymore. might try getting a hold of him and double check.



bustedknuckles -> RE: got four wheel drive? (7/24/2008 2:01:43 PM)

With the gears out of the actuator  it should be in 4x4. Just pull the gears out and put the cover back on.



exklueziv -> RE: got four wheel drive? (7/24/2008 2:07:08 PM)

ah.  so if I take the old actuator comepletly off then I will be 4x4?  Its not like I am running with any cats since travis is touring the US with his trailor I've been riding at river run with a few hondas and havnt really needed the 4x4 to show em up. where do you get your parts? I need bearings and a starter and some ujoints.  Want em cheap.  OEM is so high on atv parts.



bustedknuckles -> RE: got four wheel drive? (7/24/2008 2:14:06 PM)

If you take it completely off you will need to seal up the hole that the pin sticks out of to keep water and mud out. I pretty much buy everything from Steel Horses. Its just easier for me.



exklueziv -> RE: got four wheel drive? (7/24/2008 2:25:36 PM)

gotcha..  he's to da#n far for me to get bearings brake pads.  I need to order all my stuff today.  its all easy stuff on my bike.  the gohillas on the polaris are stuck in the diff though[&:] got it split apart and the ends soaking in diesel.  May have to get some new cups from G-unit (that's what I'm gonna call em from now on)

we got dry trails down here BTW.  you guys need to plan to come down in the fall after a good rain.



GWC -> RE: got four wheel drive? (7/24/2008 3:07:50 PM)

Cat Bargins on ebay has had a few of them for prety fair prices.  but if you leave it on the diff you could just do like you said and pull/pull the pin to make sure its in 4wd and then ride it like that untill you can get a new one.



bustedknuckles -> RE: got four wheel drive? (7/24/2008 3:41:54 PM)

He's too far for me. I just have him ship it. Normally I get within 1 or 2 days. BTW, Its been raining in crosby for 2 days. Bad thing is I'm probly gonna have to work this weekend.



exklueziv -> RE: got four wheel drive? (7/24/2008 7:20:11 PM)

that blows a fat one!  hey GWC!  come down here and ride![8D]  Tell the wife there are two mud nats this year[;)]
So you say if I pull the pin back it is in 4x4? or push it through
or like alan said and take the guts out



BLACKCATT -> RE: got four wheel drive? (7/25/2008 7:49:55 AM)

quote:

ORIGINAL: exklueziv

cuz I DONT!![:@]

I need an acuator.  anyone have a good one laying around?
Tony's got one, but he may want to keep it as a spare.
BTW tony where you get it?

I took my cover off--  so clean; no mud- but the plastic parts are cracked

also,  can I punch that pin through and run it in 4x4 until my new one comes in?  If so what is the trick to that without damaging anything?


If your board is good and you just need the plastic parts, I would try my dealer 1st. They will probably give you the plastic parts from an actuator that they swapped out. The whole actuator will cost about $185 with shipping, so I would try to beg for the free parts from the dealer 1st.

Just throwin' out another option to help save some dough!!!



exklueziv -> RE: got four wheel drive? (7/25/2008 3:46:50 PM)

yea that motor spins.  just the plastic piece that slaps that pin comes apart
I might try that.  To my surprise there is no water damage.  Its just a foul part



BLACKCATT -> RE: got four wheel drive? (7/25/2008 9:14:13 PM)

quote:

ORIGINAL: exklueziv

yea that motor spins.  just the plastic piece that slaps that pin comes apart
I might try that.  To my surprise there is no water damage.  Its just a foul part


Yea, I bet the dealer would hook you up for that piece. They won't work on them, they only swap out the whole actuator for new, so I bet they have some used ones laying around.

BTW, have you noticed the write up I did on the secondary cage mod. You have an 06', so I know you will benefit from it.

Here's the link...

http://www.highlifter.com/forum/Secondary_Cage_Mod_for_the_700_EFIs%2c_05-06_650_H1s_%26_500s/m_2783142/tm.htm



Page: [1]



Forum Software © ASPPlayground.NET Advanced Edition 2.5.5 Unicode

0.422