mudcrazee
Posts: 8065
Joined: 3/2/2005
From: Gulfport, MS
Status: offline
|
quote:
ORIGINAL: Gearslayer quote:
ORIGINAL: mudcrazee Cut the wires right at the bottem of the connector and solder all (6) of the black/yellow to eachother, solder all (4) white wires to eachother and all (4) brown wires to eachother. I used liquid electric tape on the wires to seal it up when I was done. So that's the one? Just cut plug off...sodier...seal it and I'll be good to go right? I ask this cause I'm pretty sure I'm gonna pick up an 07 in a couple weeks. Also, great posts in here Mary. Thanks a lot for this great info. Did you do the same to the front as well? I didn't see where ya said ya did. I could be blind. I don't know if the 07's have been taken care of by the factory. I doubt it. I didn't do the front one nor has many others. For some reason it does not cause problems.
_____________________________
2005 Camo BF 750, SSATV 2" lift, JE Pistons, HL Rack Radiator, 29.5's on ITP 5's, BS, 2" Exhaust Snorkel, Dyna CDI, HL Module, HL Extreme Clutch, HL Diamond Bumper and Bash. BFWDP 2007 EE Rhino660 28" Outlaws on Castlerocks, Stereo system, EBC Brakes. http://community.webshots.com/user/mudcrazee http://www.southernswampboyz.com
|